Posted by Admin on 9/5/2012 to
A porcelain tile is lovely and so is ceramic tile. They’re also easy-to-install. They won’t cause you any hassles at all if you were aware of these tips and suggestions on how to install it at home. Usually, a tile of this type is made durable because it’s sand-fired at extremely high temperatures. These are also water resistant and stronger compare to ceramic tiles. You can expect porcelain tiles to last for many years. Because they’re more durable, you can expect your investment to be worthy. Below are simple steps to set up your tiles:
- Clean your subfloor to make sure that there is no debris or dirt that can become a burden when you install the tiles. These could affect how your tiles will bond to the tile adhesives. You might want to hammer some nails that are sticking up. You can also use a power drill to put those screws below the subfloor’s surface. Remember that your flooring material needs not be leveled, but it has to be flat enough.
- Draw lines for references. You can start installing porcelain tile by looking for the middle or center of your room. Start measuring the width of your flooring, and then divide that into two. The same goes for the length. Divide the total length by two. Mark your flooring to see indicators. You can snap a chalk line on them, so they’re easier to see. These lines would indicate lines of the grout.
- Put tile glue to a clean and dry plastic bucket. It is adhesive known as thinset. It’s usually for sale as powder which needs to be mixed up with water. You can add in water based from maker instructions. Use a mixing tool attached to your power drill tot mix the adhesive well. It should be like a pancake batter. It has to rest for about ten minutes to make sure that water is totally absorbed.
- Drop an adhesive to the floor to install porcelain tile. Make sure it covers about one square. Comb it. Hold your trowel while working.
- Put a thin layer of thinset on your tile.
- Begin tiling from the center.
- Lay another tile in the same area as the first.
- Tap your tiles using a mallet. Check the level after every six tiles you seat on the floor.
- Wait for the tile thinset to dry for one day before marking some tiles that you need to cut.
- When cutting tiles, wear eye protection. This is because porcelain tile is hard and strong. Use a saw with a sled to put the tile on. Use a miter gauge to align. Don’t turn on the saw until you line everything.
- Set the tiles in place by buttering their backs with adhesives.
- Mix some grout. Follow maker instructions.
- Force grouts in between your porcelain tile. Wipe it diagonally across all joints. Clean up excess grout.
- Polish your tiles with another sponge and water.
For the best porcelain tile you can use to install for your home, log on to Tile-stones.com now.